4x4 Accessories at OKoffroad.com

Roll Cage Floor Plates


(click image for large view)

Ready for the roll cage tubing to be welded onto, our roll cage floor plates are laser cut as a 1/4" thick two-piece set consisting of a top plate and a corresponding bottom plate.

The two-piece set enables the roll cage to be tied into the frame for strength. The bottom plate is 1/2" bigger all around preventing floor pan shearing in the event of a roll-over. The 1/2" bolt hole allows up to 1/2" Grade 8 mounting hardware to be used.

The plates are shipped in bare metal ready to be welded on, then painted or powdercoated. Image shows plates with grey primer.
Sold in a set of two or singles.
Bare metal finish.
Ready for cage tubing to be welded onto.
1/4" thick steel with rounded corners.
3" X 2" bolt pattern. 1/2" bolt hole.
Top plate Dimensions: 4-1/2" x 3-1/2".
Bottom plate Dimensions: 5" x 4".
U.S. made.

Note: All roll cages should be professionally welded.
U.S. SHIPMENTS - LOWER 48
$19.95




Aluminum Sand Ladders
The real thing! Aluminum pierced plating. For vehicle recovery from mud, snow, sand and most types of soft terrain.

Waffle Boards
Light enough to carry and handle, yet still provide the maximum in strength and durability.


Re-Sellers Welcome
We are exclusive distributors for many of our listed products. We offer volume discounts, or drop-ship set-ups to retailers of 4x4 accessories and recovery gear.


Disclaimer. Please read: The effectiveness of this equipment is directly related to the manner in which it is installed, used (for off-road use only), and/or maintained. Proper installation, use and maintenance is solely the responsibility of the installer/user, and will not be assumed by OKoffroad.com.